That being said, click the download button, get the package and apply it on your computer. Moreover, constantly check with our website to stay up to date with latest releases.
It is highly recommended to always use the most recent driver version available. Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer. Without these drivers installed in Windows 10, you will start having issues while accessing the drives of your PC.
But since there are a lot of motherboards and processors out there, finding the correct driver for your storage drives can be a little difficult. You will also learn about the importance of these drivers in Windows 10 as well as how you can install them. Chances are that the hard disk drives and solid state drives connected to your computer are using SATA. As of right now, most devices use the latest SATA 3 protocol for proper drive functions. Compared to older technology, SATA provides much faster speeds for file transfers.
AHCI allows you to hot-swap disk drives in your computer due to which you can remove or connect any SATA devices to your computer without turning it off.
Before AHCI, this was not possible and every time you had to turn off your computer which was an issue for servers.
Not only that but you also get faster access time with AHCI which makes Windows 10 more responsive while using a hard drive as your boot drive. As the name suggests, it basically controls all the storage drives of your computer with AHCI protocols. It also improves the transfer speeds for large data files. IDE , which is commonly known as ATP, is an older technology for handling storage drives in the computer.
The biggest difference between these two controller types is hot-swapping ability. Not only that but IDE lacks the support for native command queuing. The connector cable itself is also quite thin and flexible for the case of SATA. To perform the latter task, get the package, run the available setup and follow the instructions displayed on-screen for a complete installation.
Afterwards, perform a system reboot so that all changes take effect, enter BIOS menu, and set the SATA option to the mode that best describes the newly applied drivers. So, if you intend to modify the SATA settings to the mode described by this release, click the download button, and make the desired changes. It is highly recommended to always use the most recent driver version available. Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver.
Problems can arise when your hardware device is too old or not supported any longer. It shouldn't be necessary to install a SATA controller driver. In the drives selection window, select Load Drivers and browse to the unzipped. On the Security tab, click the Trusted Sites icon. Click Sites and then add these website addresses one at a time to the list: You can only add one address at a time and you must click Add after each one.
DPC running after the controller is stopped causing the system to crash.
0コメント